Content
Interconnecting Cisco Network Devices Part 2 v1.0
This set of lab exercises (lab bundle) contains all the exercises associated with the Interconnecting Cisco Network Devices Part 2 (ICND2) course. The exercises cover reviewing knowledge from the ICND Part 1 course, switched networks, OSPF and EIGRP, access lists and NAT, as well as IPv6 and using the Frame Relay WAN network. The lab exercises are based on the fact that you are familiar with the basic technology aspects and they allow you to primarily focus on the configuration.
Content
This set of lab exercises contains the following exercises:
- Implementing a Small Network (Review Lab)
- Configuring Expanded Switched Network
- Troubleshooting Switched Networks
- Implementing OSPF
- Troubleshooting OSPF
- Implementing EIGRP
- Troubleshooting EIGRP
- Implementing and troubleshooting ACLs
- Configuring NAT and PAT
- Implementing IPv6
- Establishing a Frame Relay WAN
- Troubleshooting a Frame Relay WAN
Objectives
Upon finishing this set of exercises, you will be able to:
Review your knowledge from the Interconnecting Cisco Network Devices Part 1 (ICND1) course
- Configure VTP, VTP mode and a VTP domain on a Cisco Catalyst switch
- Configure separate VLANs on a Cisco Catalyst switch
- Configure and monitor the Rapid-Per-VLAN Spanning Tree Protocol on a Cisco Catalyst switch
- Enable and verify routing with OSPF on a Cisco router
- Monitor and debug OSPF routing on a Cisco router
- Configure and verify routing with EIGRP on a Cisco router
- Monitor and debug routing with EIGRP on a Cisco router
- Create and troubleshoot an IP extended access list to block Telnet and TFTP traffic on a Cisco router
- Configure and verify NAT Overload (PAT) operation on a Cisco router
- Configure basic IPv6 and dual-stack routing on a Cisco router
- Enable and verify a Frame Relay connection on a Cisco router
- Configure and verify Frame Relay subinterfaces on a Cisco router
- Troubleshoot the Frame Relay connection on a Cisco router
Importance
This lab bundle is highly recommended to all students relatively new to the internetworking. The exercises contain common network configurations to give you experience in configuring and verifying the technologies covered in the ICND2 course. The lab bundle is also recommended to students who have attended the ICND or ICND2 course in the past and would like to improve or refresh their configuration skills.
Target Audience
The labs are targeted at pre- and post-sales technical support engineers who have to design, implement and troubleshoot their networks for basic operation.
Prerequisite Knowledge
To successfully complete this set of exercise, you need basic networking knowledge, skills in configuring and troubleshooting on Cisco IOS. This knowledge is best gained by attending Interconnecting Cisco Network Devices Part 2 (ICND2) course.